Beard Growth 101

When March rolls around people in the Pacific NW start to see days where the sun comes out and it doesn’t rain. This signal of the seasons means it’s time to start thinking about boating again. Where things get sticky is when boaters who at the end of last season were tired or complacent walk down to where their dingy was left in the water.

There it sits (or floats) dirty , floppy, full of stagnant water and wearing a beard of growth that would make a modern day hipster proud. Of course this beard could have been avoided by proper maintenance and storage.

Some boaters don’t have the choice of pulling their inflatable boat or rib when it’s not in use. For these boaters a simple two part process can help to prevent or eliminate the dreaded beard. Aurora Marine makes products that are simple to use cheap and effective.

Steps To A Clean Boat.

First if the boat  has substantial growth Aurora makes Inflatable Bottom Spray that removes algae, barnacles, zebra mussles etc. from hypalon, pvc, and fiberglass. Just wet the hull, shake the bottle and spray it on. Let the spray work for about 20-30 minutes then rinse and repeat if necessary.

Step Two: Prep the boat for Aurora Poly Guard by using Aurora Speed Clean

Speed Clean is a cleaner/restorer and is suitable for use all over your inflatable boat or rib. It is the secret sauce IBC uses when people bring in old dirty floppy for repairs. The customer would always ask us what we used to clean the area of interest and invariably it was Speed Clean.

Step Three: Application of Aurora Poly Guard UV Protector.

Aurora Poly Guard UV Protectant and Polish is suitable to use all over your inflatable boat or rib, hypalon, pvc, fiberglass, nylon etc. It is non greasy, non slippery, doesn’t get on your clothes or person and lasts for a whole season. Apply two coats of Aurora Poly Guard to the bottom of your inflatable boat or rib in preparation for the anti fouling product Repelin.

Step Four: Application of Repelin Foul Release Coating.

The Aurora Repelin Foul Release Coating speaks for it’s self by eliminating or greatly reducing marine growth. Two coats is all you need to apply after the Poly Guard. It’s one of the most stolen items from boat houses because it works! If you have any algae on the bottom of your boat it just wipes off and leaves a slick fast surface.

By following the simple steps above you won’t be faced with the woes of inattention when you go to use your dinghy. As always keep your boat tight and look for adventure at the horizon.

If you have any questions about Aurora products or anything in general give us a call (503)235-2628!

For more cleaners and conditioners visit our Cleaners And Conditioners section online.